All-round surface heating
Through this type of construction, natural turbulence is created, providing optimum temperature distribution in the waterbath.
Material stainless steel
Over many years of practical use, high-grade stainless steel has proved to be superior to coated sheet steel, which can corrode rapidly during extended use.
- Temperature progress and monitoring device
For standard heating tasks in the laboratory, the Basic class is recommended for our waterbath. An electronic PID controller with an integrated self-diagnosing system, as well as a high-quality platinum temperature sensor Pt100 ensure exact temperature control. The double protection from overtemperature provides valuable protection for the load in the Memmert heating bath for the medium water.
- Temperature range: 10 °C to 95 °C plus boiling stage
- Temperature variation (time): < ±0.5 °C at 95 °C
- Double overtemperature protection: If the electronic heating control should fail, heating is switched off at a fixed level of 10 °C above the setpoint. In addition a mechanical temperature limiter, TB, switches off heating permanently if the maximum permitted bath temperature set at the factory is exceeded by 30°C, or if the fluid level is too low.
- A high-quality platinum temperature sensor Pt100 (DIN class A) in a 4-wire circuit (for stable long-term transmission of measurement signals)
- Programmable digital timer (1 min. to 99 hrs 59 min. with adjustment to the minute) for setting the Delay (delayed programme start) as well as Hold (residual operation time)
- Visual alarm if set temperature is exceeded by more than 10 °C and if heating is switched off by temperature limiter TB
